Barco FSN Series User Manual page 40

2. FSN-1400 Orientation
Card Descriptions
Following are descriptions of all components on the System card's rear I/O:
9)
10) Ethernet Port
Figure 2-5. Ethernet Connector
11) Ref In
12) Loop
40
~
Use the Com Setup Menu to change the IP address if required. In
Chapter 6, refer to the
for details.
Serial Ports
Two DB-9 connectors are provided for Serial connections. In Appendix A, refer to
the "Serial Connectors" section on page 317 for details.
Note This function is currently not implemented.
One RJ-45 connector is provided for a 10/100 Ethernet connection between the
FSN Series control panel and the FSN-1400. For multiple Ethernet connections,
an Ethernet switch is recommended. There are two LEDs on the connector:
Link Speed
Link/Activity
~
When a valid link is present, the amber Link Speed LED indicates
100mb Ethernet speed when lit, and 10mb speed when off.
~
The green Link/Activity LED indicates that a link is present when lit, and
link activity when blinking.
Please note:
~
In Appendix A, refer to the
for Ethernet connector pinout details.
~
Use the Com Setup Menu to change the chassis' IP address. In
Chapter 6, refer to the
for details.
~
Refer to the "FSN Series Ethernet
more information about Ethernet.
One BNC is provided for an analog Reference Input connection. Accepted video
reference signals are black burst, SMPTE bi-level sync and tri-level sync.
Note In Appendix A, refer to the
Specifications" section on page 309 for detailed information
about the allowed frame rates for the reference input.
One BNC connector is provided for a reference Loop connection, which enables
you to loop the incoming reference signal to the next device in your system. If the
reference Loop is not used, connect a 75 ohm terminator to the connector.
"Communications Setup" section on page 247
"Ethernet Connector" section on page 316
"Communications Setup" section on page 247
Connections" section on page 42 for
"Reference Video Input
FSN Series • User's Guide