Barco FSN Series User Manual page 188

5. Menu Orientation
System Menu
oÉ~ê=fLl=sáÉï=aÉëÅêáéíáçå
The figure below illustrates a sample Rear I/O View on the Input Menu :
Slot 1
1
2
3
4
5
6
7
8
NIC
Figure 5-81. Input Menu, Rear I/O View (sample)
The Rear I/O View shows the I/O panels for FSN-1400 slots 1 through 7 , which can be
used for input cards. This view always matches your system configuration exactly —
based on the installed cards. Please note:
•
•
•
•
•
Analog 1
DVI 1
SDI 1
Refer to the "
I/O View connectors.
188
Slot 2 Slot 3 Slot 4 Slot 5
1
Analog 1
2
DVI 1
3
SDI 1
4
5
SDI 2
6
DVI 2
7
Not Not
Installed Installed
Analog 2
8
NIC UIC
The number of each slot is shown along the top.
The type of each installed card is shown along the bottom (e.g., NIC , UIC ).
If a card is not installed, the label " Not Installed " appears in the slot.
To set up a native input, press the desired connector on a NIC . The yellow border
indicates that the connector is selected, and in the Input Table , the input is
automatically highlighted.
To set up a universal input:
~
Press any of the top three connectors to select Input 1 , or any of the
bottom three connectors to select Input 2 . The selected input is
highlighted with a yellow border around all three connectors.
~
Next, press the desired connector (either Analog , DVI or SDI ) to
highlight it with a green border. This indicates that the connector is
selected, and in the Input Table , the input is automatically highlighted.
Please note:
~
When you switch connectors on the UIC , freeze will always be turned off.
If " Black on Invalid Video " is turned on, the input will go black as it
acquires the new input.
Connector Colors " section on page 189 for important information about Rear
Slot 6 Slot 7
Not Not
Installed Installed
FSN Series • User's Guide