Figure 190 How To Insert A Front-Loadable Module - Agilent Technologies 8163A Manual

Using Modules
CAU T ION
CAU T ION
Agilent 8163A/B, 8164A/B & 8166A/B Mainframes, Sixth Edition
All manuals and user guides at all-guides.com
How to Fit a Front-Loadable Module
Do not use the electrical or optical connectors to push the module
into the instrument, as this can cause damage to the connectors.
Make sure that the line power is switched off before you fit a
module.

Figure 190 How to Insert a Front-Loadable Module

1 Position the module at an unoccupied slot, with the catch at the bottom front of
the module.
2 Insert the module into the slot and onto the tracks. If the module does not slide
in freely, check that you have correctly positioned and correctly oriented it and
that there is no obstruction to its movement.
3 Apply pressure to the front panel, and push the module as far as it goes. You
hear a small click when the module reaches its installed position. This is the
catch making contact.
How to Remove a Back-Loadable Module
Disconnect all electrical and optical connectors before you remove
this module from the instrument, as this can cause damage to the
connectors.
Make sure that the instrument is in stand-by mode, see page 292,
before you remove a module.
Installation and Maintenance
303