Cleaning Instructions; Table 23 Cleaning Instructions For Modules - Agilent Technologies 8163A Manual

16

Cleaning Instructions

Table 23 Cleaning Instructions for Modules

Agilent 8163A/B, 8164A/B & 8166A/B Mainframes, Sixth Edition
All manuals and user guides at all-guides.com
The following Cleaning Instructions contain some general safety
precautions, which must be observed during all phases of cleaning.
Consult your specific optical device manuals or guides for full information
on safety matters.
Please try, whenever possible, to use physically contacting connectors,
and dry connections. Clean the connectors, interfaces, and bushings
carefully after use.
If you are unsure of the correct cleaning procedure for your optical device,
we recommend that you first try cleaning a dummy or test device.
Agilent Technologies assume no liability for the customer's failure to
comply with these requirements.
Cleaning Instructions for this Instrument
The Cleaning Instructions apply to a number of different types of Optical
Equipment. Table 23 lists the sections that are relevant to the various
modules that can be installed in this instrument.
Modules
Optical Heads
Laser Source Modules
Tunable Laser Modules
Return Loss Modules
LED Source Modules
Power Sensor Modules
Instruction
"How to clean instruments with an optical glass plate" on
page 441
"How to clean instruments with a physical contact interface"
on page 442
"How to clean instruments with a physical contact interface"
on page 442
"How to clean instruments with a physical contact interface"
on page 442
"How to clean instruments with a physical contact interface"
on page 442
"How to clean instruments with a recessed lens interface" on
page 443
421