Agilent Technologies 8163A Manual page 401

Return Loss Meters
error message
description
test value
action
error message
description
test value
action
error message
description
test value
action
error message
description
test value
action
error message
description
test value
action
Agilent 8163A/B, 8164A/B & 8166A/B Mainframes, Sixth Edition
All manuals and user guides at all-guides.com
E10040: 10bit ADC test failed (a, b, c)
The 10bit ADC has returned a value other than 512
a
b
c
Please return the unit to your local service center for repair
E10051: Laser <a> temp out of limits (b)
The laser temperature is outside the allowed range
a
b
Verify whether the module is operated within the specified ambient
temperature. If the failure persists, please return the unit to your lo-
cal service center for repair
E10052: Photodiode <a> temp out of limits (b)
The photodiode temperature is outside the allowed range
a
b
Verify whether the module is operated within the specified ambient
temperature. If the failure persists, please return the unit to your lo-
cal service center for repair
E1x060: 0.25V offset failed (a, b)
Verifies that the offset voltage for the 16-bit ADC (250 mV) is cor-
rectly added to the input signal
a
b
x
Please return the unit to your local service center for repair
E1x061: PGA DAC adj failed (a, b, c)
Tries to adjust the offset voltage of the PGA
a
b
c
x
Please return the unit to your local service center for repair
shows the ADC reading
shows the lower limit
shows the upper limit
laser number
measured laser temperature
photodiode number
measured photodiode temperature
shows the ADC reading
shows the maximum difference to the exact ADC reading
of 3277
refers to the internal PM channel tested
shows the ADC Offset reading
shows the limit for an upper offset
shows the limit for a lower offset
refers to the internal PM channel tested
Error Messages
401