Display/Key Functional Test - Agilent Technologies 8163A Manual

Performance Test Instructions
Agilent 8163A/B, 8164A/B & 8166A/B Mainframes, Sixth Edition
All manuals and user guides at all-guides.com

Display/Key Functional Test

1 Setup the test equipment as shown in Figure 201 :
Insert the fixed laser source module in slot 1 and the power sensor in slot 2. If
you use the Agilent 8164A/B Lightwave Measurement System, insert the back-
loadable Tunable Laser module, if available, in slot 0.
2 Switch on the mainframe and wait until it has booted.
Testing Hardkeys
1 Press Config. You should see the Configuration menu.
2 Press Aux. You should hear a "beep" and the Configuration menu should
disappear.
3 Press Appl. You should hear a "beep".
4 Press Help. You should hear a "beep".
5 Press Preset, the green hardkey. An egg-timer icon should be displayed while
all parameters are set to their default values. The Overview Screen showing all
channels should appear.
6 Press Channel several times.
The highlighted field on the display should toggle between the channels you
have inserted a module into.
Testing the Softkeys and the Cursor Key
1 Press the right arrow of the cursor key several times.
Check the fields on the display being highlighted one after another.
2 Press the left arrow on the cursor key several times.
Check the fields on the display being highlighted one after another.
3 Press the up arrow on the cursor key several times.
Check the fields on the display being highlighted one after another.
4 Press the down arrow on the cursor key several times.
Check the fields on the display being highlighted one after another
5 Using the cursor key, move to the power parameter, [P], of the Power Sensor
module.
Testing the Softkeys and the E
1 Press [Menu]. The menu should appear.
2 Press [Close]. The menu should disappear.
3 Press [Details]. The details screen should appear. You should see the [Cal],
[Ref], and [Range] parameters in addition to [P] and [λ]. If you use the
Performance Tests
Key
NTER
355