How To Clean Optical Devices Which Are Sensitive To Mechanical Stress And Pressure - Agilent Technologies 8163A Manual

All manuals and user guides at all-guides.com
Cleaning Instructions

How to clean optical devices which are sensitive to mechanical stress and pressure

How to clean optical devices
which are sensitive to
mechanical stress and pressure
Some optical devices, such as the Agilent 81000BR Reference Reflector,
which has a gold plated surface, are very sensitive to mechanical stress or
pressure. Do not use cotton-swabs, soft-tissues or other mechanical
cleaning tools, as these can scratch or destroy the surface.
Preferred Procedure
Use the following procedure on most occasions.
1 Blow away any dust or dirt with compressed air.
Procedure for Stubborn Dirt
To clean devices that are extremely sensitive to mechanical stress or pressure you
can also use an optical clean polymer film. This procedure is time-consuming, but
you avoid scratching or destroying the surface.
1 Put the film on the surface and wait at least 30 minutes to make sure that the
film has had enough time to dry.
2 Remove the film and any dirt with special adhesive tapes.
Alternative Procedure
For these types of optical devices you can often use an ultrasonic bath with
isopropyl alcohol. Only use the ultrasonic bath if you are sure that it won't cause
any damage anything to the device.
1 Put the device into the bath for at least three minutes.
2 Blow away any remaining liquid with compressed air.
If there are any streaks or drying stains on the surface, repeat the cleaning
procedure.
444
Agilent 8163A/B, 8164A/B & 8166A/B Mainframes, Sixth Edition