Running A Stability Application; Figure 159 The Stability Measurement Screen - Measurement Running - Agilent Technologies 8163A Manual

Applications
260
All manuals and user guides at all-guides.com

Running a Stability Application

17You can run the stability application by pressing [Measure]. The Stability
Measurement screen, as shown in Figure 159 , appears. A progress bar shows
the proportion of the stability application that has been completed.

Figure 159 The Stability Measurement Screen - Measurement Running

18There are two softkeys available from the Stability Measurement screen.
• Press [Graph] to view a graph of the Measurement results as the results are
measured. Press [Close] to return to the Stability Measurement screen. See
"Working with Application Graphs" on page 231 for information on zooming
in and out.
• Press [Cancel] to return to the Stability Setup screen without completing the
stability application.
19When the stability application completes, you hear a beep, an hourglass
appears momentarily. If you are viewing the Stability Measurement Screen, the
available softkeys change as shown in Figure 159 .
Agilent 8163A/B, 8164A/B & 8166A/B Mainframes, Sixth Edition
The Stability Application