Moneris iCT250 Getting Starded Manual page 16

13. Enter your static IP parameters:
a. Scroll down to TERMINAL ADDR, and press the green
b. Key in the terminal's IP address, and press the green
Note: To key in a decimal point, press the 0 (zero) key and then press the
The TERMINAL SETUP menu appears.
c. Scroll down to MASK ID, and press the green
d. Key in the terminal's Mask ID, and press the green
The TERMINAL SETUP menu appears.
e. Scroll down to GATEWAY, and press the green
f. Key in the terminal's Gateway Address, and press the green
The TERMINAL SETUP menu appears.
g. Scroll down to PORT NUMBER, and press the green
h. Key in the port number that the ECR is configured to use to communicate with the
terminal, and press the green
The TERMINAL SETUP menu appears.
i. Press the red
The ETHERNET SETUP menu appears.
14. Enter the terminal's DNS address:
a. Scroll down to DNS SETUP, and press the green
b. Press the green
c. Key in the terminal's Primary DNS address, and press the green
d. Scroll down to SEC ADDRESS, and press the green
e. Key in the terminal's Secondary DNS address, and press the green
f. Press the red
The ETHERNET SETUP menu appears.
15. Press the red key twice.
The REBOOT TERMINAL message appears and then the terminal reboots.
16. When the REINITIALIZATION REQUIRED screen appears, press the
17. When the ENTER ADMIN CODE entry screen appears, key in 11, and press the green
18. When the HOST SETUP menu appears, press the red
19. When the TCP HOST CONNECTION OK PRESS OK message appears, press the green
Note: The Ethernet icon
 If the HOST CONNECTION FAILED message or the TCP CONNECTION FAILED appear, press
the green key (see page 29 to do troubleshooting).
12 iPP320 Getting Started Guide for the POSPAD Application
key.
key once.
key to select PRIM ADDRESS.
key once.
at the top of the screen will be coloured green.
key.
key.
key.
key.
key.
key.
key.
key.
key.
key.
key.
key twice.
key once.
key.
key.
key.