Configuring Terminal-To-Host Communication Parameters; Using Dynamic Ip To Communicate With Moneris Test Host - Moneris iCT250 Getting Starded Manual

1.7 Configuring terminal-to-host communication
parameters
The terminal must be able to communicate with the Moneris Test Host to process transactions.
You may configure the terminal to use dynamic IP, static IP, or dial as the default means of
communication with the Moneris Test Host if the terminal-to-ECR communication type you are
planning to use supports it.
1. Refer to the table below to determine if the configuration you wish to use is supported:
Ethernet networking
RS232 serial cable
USB cable
2. Do one of the following based on your requirements:
 To configure the terminal to use dynamic IP over Ethernet (as default) to communicate
with the Moneris Test Host, follow the instructions below.

To configure the terminal to use static IP over Ethernet (as default) to communicate with
the Moneris Test Host, follow the instructions on page 11.
 To configure the terminal to use dial (as default) to communicate with the Moneris Test
Host, follow the instructions on page 13.

1.7.1 Using Dynamic IP to Communicate with Moneris Test Host

Note: This option is not available when the terminal is connected to your ECR by Ethernet
networking.
1. Begin at the REINITIALIZATION REQUIRED screen.
2. Press the key twice.
The ENTER ADMIN CODE entry screen appears.
3. Key in 11, and press the green
The HOST SETUP menu appears.
4. Scroll down to TEST, and press the green
The HOST SETUP menu appears.
5. Scroll down to ipgt1, and press the green
The REINITIALIZATION REQUIRED screen appears.
6. Press the key twice.
The ENTER ADMIN CODE entry screen appears.
7. Key in 08, and press the green
The GENERAL PARAMETERS menu appears.
Terminal-to-host communication
Dynamic IP Static IP
(default) (default)
•
• •
• •
key.
key.
key.
key.
1. Overview and configuration
Dial Dial
(default) (backup)
•
• •
• •
9