Configuring Terminal-To-Ecr Communication Parameters; Terminal Connected To Ecr Using A Usb Cable; Terminal Connected To Ecr Using An Rs232 Serial Cable - Moneris iCT250 Getting Starded Manual

1.8 Configuring terminal-to-ECR communication
parameters
Configure the terminal's Semi-Integrated mode parameters based on the connection type used to
allow the terminal to communicate with the ECR:

If the terminal is connected to the ECR via a USB cable, follow the instructions below.

If the terminal is connected to the ECR via an RS232 serial cable, follow the instructions
below.

If the terminal is linked to the ECR via Ethernet networking, follow the instructions on
page 15.

1.8.1 Terminal Connected to ECR using a USB Cable

1. Begin at the REINITIALIZATION REQUIRED screen.
2. Press the key twice.
The ENTER ADMIN CODE entry screen appears.
3. Key in 52, and press the green
The SEMI COMM CFG menu appears.
4. Scroll up to USB, and press the green
The BAUD RATE menu appears.
Note: The default setting is 19200.
Scroll to the appropriate baud rate (i.e., select the baud rate that is supported by the ECR
hardware), and press the green
The REINITIALIZATION REQUIRED screen appears.
5. Go back to Read this first: Overview procedures on page 1 (continue at step 7).

1.8.2 Terminal Connected to ECR using an RS232 Serial Cable

7. Begin at the REINITIALIZATION REQUIRED screen.
8. Press the key twice.
The ENTER ADMIN CODE entry screen appears.
9. Key in 52, and press the green
The SEMI COMM CFG menu appears.
10. Scroll to RS232, and press the green
The BAUD RATE menu appears.
Note: The default setting is 19200.
11. Scroll to the appropriate baud rate (i.e., select the baud rate that is supported by the ECR
hardware), and press the green
The REINITIALIZATION REQUIRED screen appears.
6. Go back to Read this first: Overview procedures on page 1 (continue at step7).
14 iPP320 Getting Started Guide for the POSPAD Application
key.
key.
key.
key.
key.
key.