Installing The Paper Roll - Moneris iCT250 Getting Starded Manual


If any of the above required elements is missing, contact Moneris for assistance (go to
Merchant support on the page 33).

1.2 Installing the paper roll

1. Follow these steps to install a paper roll in the terminal:
a. Lift the printer latch up, and then pull back to open the lid
(exposes the paper well).
b. Insert the paper roll into the empty paper well with the
loose end unrolling from the bottom of the roll towards the
front of the terminal.
c. Unroll enough paper to extend at least one inch (2.5 cm)
past the faceplate.
d. Close the lid, and press down to snap it back into place so
that the extended paper is pressed securely against the lid
and the faceplate.
2. Please note that once you have finished the setup procedures and have powered on the
terminal, you can advance the paper by pressing down and holding the yellow
IMPORTANT: DO NOT attempt to manually advance the paper by pulling it as this will
damage the printer.
3. Go back to Read this first: Overview procedures on page 1 (continue at step 3).
1. Overview and configuration
printer latch
paper roll (inserted)
paper (extended)
faceplate
g
paper
key.
3