Maintenance
Replacing an I/O Module
Installing an I/O Module
Perform the following steps:
1.
Examine for damage, closely inspect the interface connector. Do not
install it if the pins are bent.
2.
With the latches in the open position, slide the module into the enclosure
until the latches engage.
3.
Set the module in position by manually closing the latches. A click should
be heard as the latches engage.
The I/O module is successfully installed.
98
Electronic Overload
EMC precautions: if passive copper cables are
connected, the cable must not have a connection to a
common ground/earth point.
The I/O module may take up to one minute to re-initialize after the
cables are inserted.
SpycerNode
User Manual | 2902.3266.02 - 08