R&S Network Switch Configuration; Configure A Static Ip For Management Interface - R&S SpycerNode 2U12 User Manual

Configuration
R&S Network Switch Configuration
R&S Network Switch Configuration
The R&S network switch need an initial configuration before it can be acces-
sible for management. For best performance your network topology must
support jumbo frames.
Perform the following steps:
1. Connect the power supply.
2. Connect the serial port of the host PC to the console port of the switch
with the DB9 to RJ-45 cable. If your host PC does not have a native
serial port you can use a USB-to-RS232-Adapter.
3. Open terminal program (recommended:
4. Configure a serial terminal program.
Parameter
Baud rate
Data bits
Stop bits
Parity
Flow control
5. Log in:
OS
MLNX-OS

Configure a static IP for Management Interface

Perform the following steps:
•
Use the following commands:
switch [master] (config) # no interface mgmt0 dhcp
switch [master] (config) # interface mgmt0 ip address <IP>
<NETMASK>
54
P
UTTY
Settings
115200
8
1
None
None
Username
admin
User Manual | 2902.3266.02 - 08
SpycerNode
).
Password
admin