Table of Contents
Advertisement
Configuration
Initial Setup
Initial Setup
For initial setup the device must be integrated into a network to establish
access to the R&S
allows you to configure and monitor all R&S devices connected within a local
network.
The network connection can be done via either of the two 1Gbit network
ports at the rear of system. However, depending on which one you choose,
different settings must be applied, since the first one is set to DHCP
(Dynamic Host Configuration Protocol) and the second one to static IP
(10.0.0.4).
enp1s0f1
DHCP
enp1s0f2 - static IP
10.0.0.4
The following topics are covered:
● Using Dynamic Host Configuration Protocol (DHCP) (page 58)
● Using Static IP (page 65)
Using Dynamic Host Configuration Protocol (DHCP)
With a zeroconf capable PC/MAC it is possible to automatically detect
network services. You can also use a zeroconf browser to view all zeroconf
capable devices in your network. If your PC is not zeroconf capable use
tools such as Bonjour.exe for the automatic detection of network services or
connect your system using a static IP address ("Using Static IP" (page 65)).
58
®
Device Manager. The Device Manager is the tool that
SpycerNode
User Manual | 2902.3266.02 - 08
Advertisement
Table of Contents
