Table of Contents
Advertisement
SpycerNode
Connecting the Power Source
2U Enclosures
Perform the following steps:
•
Connect C13 AC plugs to both C14 AC connectors.
5U Enclosures
Perform the following steps:
•
Connect C19 AC to both C20 AC connectors.
SpycerNode is ready for first use.The SpycerNode hardware is now properly
installed and you can switch on the system.
User Manual | 2902.3266.02 - 08
Loss of Data/Corrupt Data
In the event of a power failure the device will be abruptly
switched off. This can result in corrupt data, loss of data and
equipment damage.
Connect the system to an uninterruptible power supply
redundantly on two phases.
Electrical Shock
If any part of the device is damaged and the exterior of the
system is still under power.
The enclosure must be grounded before applying
power.
Installation
Connecting the Power Source
47
Advertisement
Table of Contents
