Setting The Unit Identification Number - R&S SpycerNode 2U12 User Manual

SpycerNode

Setting the Unit Identification Number

The unit identification number is not set before the first system power on.
The display is set to "00" (flashing). The enclosure continues to power up
even if the unit identification number is not set. How to set the unit identifica-
tion number is described below. With a 5U enclosures use the ID switch and
with a 2U enclosures use the mute button.
Perform the following steps:
1. Press and hold the ID switch/mute button on the operating panel for a
period of five seconds. The left-hand digit flashes.
2. Press and release the ID switch/mute button to increment the number
until the required digit is reached.
3. Press and hold the ID switch/mute button for a period of five seconds.
The right-hand digit flashes.
4. Press and release the ID switch/mute button to increment the number
until the required digit is reached.
5. Press and hold the ID switch/mute button for a period of five seconds to
finish setting the number. Values of "01" to "99" are valid.
User Manual | 2902.3266.02 - 08
Setting the Unit Identification Number
Configuration
57