Table of Contents
Advertisement
SpycerNode
Configure MTU
Configure MTU (Jumbo Frames): The Value must be 9216. These setting
have to be done for each port.
Using the network switch terminal perform the following steps.
Perform the following steps:
1.
Enter enable
2.
Enter configure terminal
3.
Enter interface [switch]/[port]-[switch]/[port]
shutdown
4.
Enter interface ethernet [switch]/[port]-[switch]/[port]
mtu 9216 (e.g. 1/1-1/16 mtu 9216)
5.
Enter no interface [switch]/[port]-[switch]/[port] shutdown
6.
Enter configuration write to save the configuration.
7.
Enter show interfaces to check the configuration.
The network switch is finally configured.
Optional
Configure port for splitter cable
Configure the port for splitter cable to connect 10Gbit clients to the switch.
Perform the following steps:
•
Enter interface ethernet 1/[port number you want to split]
module-type gsfp-split-4
Display IP interfaces
Perform the following steps:
•
Enter show IP Interface to connect via DHCP to display IP inter-
faces.
User Manual | 2902.3266.02 - 08
The terminal changes to admin mode:
switch [master] #
The terminal changes to config mode:
switch [master] (config) #
Configuration
R&S Network Switch Configuration
55
Advertisement
Table of Contents
