Table of Contents
Advertisement
Maintenance
5U Enclosures
2.
Push down and hold the red release latch (1) and pull the module out by
its handle (2).
3.
Pull the module out completely.
The cooling module is successfully removed.
Installing a Cooling Module
Perform the following steps:
1.
Rotate the cooling module so that the red release latch and handle are
on the right-hand side.
2.
Slide the cooling module into its slot until the latch clicks home. The
enclosure will automatically detect and make use of the new unit.
The cooling module is successfully installed.
118
Overheating damage
An incorrect airflow can damage components.
The cooling module bay must not be empty for more
than two minutes while the enclosure is powered.
SpycerNode
User Manual | 2902.3266.02 - 08
Advertisement
Table of Contents
