System Monitoring; Monitoring Through Snmp - R&S SpycerNode 2U12 User Manual

SpycerNode

System Monitoring

You can monitor single parts of your system using SNMP data points, or you
can use the R&S
SpycerNode and single parts of the hardware. You will be able to define crit-
ical values and configure an e-mail notification as well. Remote management
(IPMI) is also possible via the R&S
There are various methods to monitor the system:
● Monitoring through SNMP (page 89)
● Monitoring through the Device Manager (page 90)
● Monitoring Disk Arrays (page 92)

Monitoring through SNMP

The Simple Network Management Protocol (SNMP) is a standard internet
protocol for the device management in IP networks. SNMP allows you to e.g.
monitor and query the state of several SpycerNode devices in a network or
single parts of the hardware.
SpycerNode provides a RS-SPYCERNODE-V1-MIB that give you the opportu-
nity to query the state of the system or parts of it, using SNMP.
Explanation of the OIDs;
When using a monitoring software, you will have to enter all OIDs once to be
able to monitor the hardware's state continuously.
User Manual | 2902.3266.02 - 08
®
Device Manager that allows you to query the state of the
The use of notifications through the hardware manufacturers BMC
system (Ami MegaRAC/Dell iDrac) is not recommended nor sup-
ported by Rohde & Schwarz.
®
Device Manager.
Administration
System Monitoring
89