Bearing Inspection; Drive Clutch Inspection - Polaris RZR 570 2013 Service Manual

PVT SYSTEM
2. Inspect sheave surfaces. Replace the entire clutch if
worn, damaged or cracked.

BEARING INSPECTION

1. Rotate the clutch bearing in both clockwise and
counter-clockwise directions.
• Non-EBS: The non-braking bearing should rotate
both directions on the shaft with only a slight
amount of drag.
• EBS: The one-way bearing should rotate clockwise
(when viewed from cover plate side) with only a
slight amount of drag. When rotated counter-
clockwise the one-way bearing should lock to the
shaft without slipping.
2. Verify there is no binding or rough spots. If problems
are noted continue with disassembly.
5.20

DRIVE CLUTCH INSPECTION

Remove cover, spring, and spider following instructions
for drive clutch removal, then proceed as follows:
1. Remove the moveable sheave spacer sleeve
Inspect for damage and wear.
2. Remove the moveable clutch sheave
damage and wear.
9926813 R04 - 2013-2016 RZR 570 Service Manual
NOTE
w
. Inspect for
© Copyright Polaris Industries Inc.
q
.