All Wheel Drive Coil; Operation Overview; Diagnosing System Failures - Polaris RZR 570 2013 Service Manual

9926813 R04 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.

ALL WHEEL DRIVE COIL

OPERATION OVERVIEW

• When the AWD switch is "ON", 12 VDC power is
present at the hub coil.
• If the criteria is met, the Engine Controller provides a
ground path (brown/white wire). When this occurs the
AWD icon should display in the instrument cluster.
• The AWD system must be grounded to operate.

DIAGNOSING SYSTEM FAILURES

• Verify the AWD switch is functional and that a
minimum of 11 volts is present at the hub coil.
• Verify the AWD hub coil is functional. Test the AWD
hub coil using an ohm meter. See specifications below:
AWD Hub Coil Resistance:24 Ohms ± 5%
• Verify the wiring harness, wiring, connectors,
connector pins and grounds are undamaged, clean
and connect properly.
• Verify continuity of wire connections with a known
good volt/ohm meter.
NOTE
Verify all wires and wiring connections have been
tested properly with a known good volt/ohm meter
before suspecting a component failure. 80% of all
electrical issues are caused by bad/failed connections
and grounds.
ELECTRICAL
11
11.19