Clutch Assembly - Polaris RZR 570 2013 Service Manual

u
9. Remove the E-clip , washer
both rollers in the stationary sheave for wear. If
rollers are worn, you must inspect the helix for wear.
If the helix roller surface
driven clutch assembly will be needed.
s
10. Inspect the bearings inside the moveable sheave.
If it is significantly worn, the clutch must be replaced.
11. Inspect driven clutch sheave faces for wear or
damage.
12. Clean and inspect splines on helix and transmission
input shaft.
13. Lube splines with a light film of grease. Do not
lubricate the bearings!
9926813 R04 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.
i o
and roller . Check
a
is worn down, a new

CLUTCH ASSEMBLY

1. Install the rollers, washers and E-clips.
q
2. Align the "X" marks on each of the sheaves.
3. Install the same thrust washers
sheaves as removed during disassembly.
4. Assemble the clutch sheaves by aligning the rollers
and the helix.
5. Position the spring washer (early build only), spring,
spring cup and retaining ring into moveable sheave.
Do not apply oil or grease to the bearings.
PVT SYSTEM
w
between the 5
5.27