Front Bearing Replacement - Polaris RZR 570 2013 Service Manual

FINAL DRIVE
13. Replace bearing if moisture, dirt, corrosion, or
roughness is evident.
Due to extremely close tolerances and minimal wear,
the bearings must be inspected visually, and by feel.
While rotating bearings by hand, inspect for rough
spots, discoloration, or corrosion. The bearings should
turn smoothly and quietly, with no detectable up and
down movement and minimal movement sideways
between inner and outer race.

FRONT BEARING REPLACEMENT

Bearing Removal
1. Remove the outer snap ring.
2. From the back side of the bearing carrier, tap on the
outer bearing race with a drift punch in the reliefs as
shown.
3. Drive bearing out evenly by tapping on outer race
only. Once bearing is at bottom of casting, support
casting on outer edges so bearing can be removed.
7.4
NOTE
4. Inspect the bearing carrier housing for scratches,
wear or damage. Replace front bearing carrier if
damaged.
Bearing Installation
5. Thoroughly clean the front bearing carrier housing
and the outer race on the new bearing. Be sure that
all oil residue has been removed from each surface.
6. Support the bottom of the bearing carrier housing.
CAUTION
Use an arbor and press only on the outer race,
otherwise bearing damage may occur.
7. Apply Loctite ® 603 ®
circumference of the new bearing race and carefully
press the new bearing into the bearing carrier
housing.
Use care to not allow any of the Loctite
get in the bearing.
8. Wipe the housing clean of any excess compound
and install the snap ring.
9926813 R04 - 2013-2016 RZR 570 Service Manual
retaining compound to the outer
NOTE
® compound to
© Copyright Polaris Industries Inc.