Charging Procedure - Polaris RZR 570 2013 Service Manual

CHARGING PROCEDURE

1. Remove the battery to prevent damage from leaking
or spilled acid during charging.
2. Charge the battery with a charging output no larger
than 1/10 of the battery's amp/hr rating. Charge as
needed to raise the specific gravity to 1.270 or
greater.
3. Install battery in vehicle. Coat threads of battery bolt
with a corrosion resistant dielectric grease.
Dielectric Grease:PN 2871329
4. Connect battery cables.
WARNING
To avoid the possibility of explosion, connect positive
(+) cable first and negative (-) cable last.
5. After connecting the battery cables, install the cover
on the battery and attach the hold down strap.
6. Install clear battery vent tube from vehicle to battery
vent. WARNING: Vent tube must be free from
obstructions and kinks and securely installed. If not,
battery gases could accumulate and cause an
explosion. Vent should be routed away from frame
and body to prevent contact with electrolyte. Avoid
skin contact with electrolyte, as severe burns could
result. If electrolyte contacts the vehicle frame,
corrosion will occur.
7. Route cables so they are tucked away in front and
behind battery.
9926813 R04 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.
ELECTRICAL
11
11.31