Pad Inspection; Pad Assembly / Installation - Polaris RZR 570 2013 Service Manual

BRAKE SYSTEM

PAD INSPECTION

1. Measure the thickness of the pad material. Replace
pads if worn beyond the service limit.
Front Brake Pad Thickness:
.300 ± .007" (7.6 mm ± .178 mm)
Service Limit: .180" (4.6 mm)
9.18

PAD ASSEMBLY / INSTALLATION

1. Lubricate mounting bracket pins with a light film of
silicone grease and install rubber dust boots.
2. Compress mounting bracket and make sure dust
boots are fully seated. Install pads with friction
material facing each other.
WARNING
If brake pads are contaminated with grease, oil, or
liquid soaked do not use the pads. Use only new, clean
3. Install caliper onto front hub and torque new
mounting bolts to specification.
TORQUE
Front Caliper Mount Bolt:
30 ft-lbs (41 Nm)
4. Slowly pump the brake pedal until pressure has been
built up. Maintain at least 1/2, (12.7 mm) of brake
fluid in the reservoir to prevent air from entering the
brake system.
9926813 R04 - 2013-2016 RZR 570 Service Manual
pads.
© Copyright Polaris Industries Inc.