Polaris RZR 570 2013 Service Manual page 341

8. Apply Loctite ® 271 (Red) to the outer circumference
of the new upper bearing race. Slide the new upper
bearing onto the steering shaft and press it into the
pivot tube by hand.
NOTE
Use care not to allow any of the Loctite
bearing.
Bearings will be seated in the pivot housing upon
tightening the steering wheel nut in step 14.
9. Reinstall the upper washers and spacers in the order
in which they were removed.
10. Install the steering wheel and hand tighten the nut.
11. Reinstall the steering shaft assembly in the vehicle.
Install the lower portion of the steering shaft onto the
steering gear box assembly (see Figure 5-16).
Torque the lower pinch bolt to specification.
TORQUE
Lower Pinch Bolt:
36 ft-lb (48 Nm)
9926813 R04 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.
12. Install the two fasteners that retain the pivot tube
(see Figure 5-17). Torque fasteners to specification.
® to get in the
13. Install the fastener retaining the upper portion of the
steering wheel tilt shock to the pivot tube (see Figure
5-17). Torque fastener to specification.
14. Be sure the front wheels are facing straight forward.
Remove the steering wheel and align as needed.
Torque the steering wheel nut to specification.
15. Wipe the pivot tube clean of any excess Loctite.
16. Install steering wheel cap and field test steering
operation.
STEERING / SUSPENSION
TORQUE
Pivot Tube Fasteners:
23 ft-lb (31 Nm)
TORQUE
Tilt Shock Fastener:
7 ft-lbs (10 Nm)
TORQUE
Steering Wheel Nut:
65 ft-lbs (88 Nm)
®
8
8.5