Steering; Steering Inspection; Tie Rod End / Wheel Hub Inspection - Polaris RZR 570 2013 Service Manual

MAINTENANCE

STEERING

STEERING INSPECTION

The steering components should be checked periodically
for loose fasteners, worn tie rod ends, ball joints, and
damage. Also check to make sure all cotter pins are in
place. If cotter pins are removed, they must not be re–
used. Always use new cotter pins.
Replace any worn or damaged steering components.
Steering should move freely through the entire range of
travel without binding. Check routing of all cables, hoses,
and wiring to be sure the steering mechanism is not
restricted or limited.
WARNING
Whenever steering components are replaced, check
front end alignment.
Due to the critical nature of the procedures outlined in
this chapter, Polaris recommends steering component
repair and adjustment be performed by an authorized
Polaris MSD certified technician.
Use only genuine Polaris replacement parts.
2.28

TIE ROD END / WHEEL HUB INSPECTION

• To check for play in the tie rod end, grasp the steering
tie rod, pull in all directions feeling for movement.
• Replace any worn steering components. Steering
should move freely through entire range of travel
without binding.
• Elevate front end of machine so front wheels are off
the ground. Check for any looseness in front hub/
wheel assembly by grasping the tire firmly at top and
bottom first, and then at front and rear. Try to move the
wheel and hub by pushing inward and pulling outward.
• If abnormal movement is detected, inspect the hub and
wheel assembly to determine the cause (loose wheel
nuts or loose front hub nut).
• Refer to Chapter 7 "Final Drive" for front hub service
procedures.
9926813 R04 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.