Polaris RZR 570 2013 Service Manual page 244

PVT SYSTEM
SITUATION PROBABLE CAUSE
Belt slippage due to water, oil, grease, etc.,
rubbing on cover.
Clutches or weight being applied to cover
while in operation.
High vs. low range.
Cover seals or ducts leaking.
Operator error.
Water ingestion
Belt worn out.
Belt slippage Water ingestion.
Belt contaminated with oil or grease.
Belt worn or separated, thin spots, loose
belt.
PVT noise
Broken or worn clutch components, cover
hitting clutches.
Thin spots on belt, worn belt .
Engagement
erratic or stabby
Drive clutch bushings stick.
5.38
REMEDY
Inspect system. Clean , repair or replace as
necessary.
Seal PVT system ducts.
Remove weight. Inform operator
Instruct operator on guidelines for operation in
proper driving range for different terrain as
outlined in Owner's Safety and Maintenance
Manual.
Find leak and repair as necessary.
Instruct operator on guidelines for operation in
wet terrain as outlined in Owner's Safety and
Maintenance Manual.
Replace belt.
Inspect and seal PVT system.
Inspect and clean.
Replace belt.
Inspect and repair as necessary.
Replace belt. Refer to belt burnt troubleshooting
and instruct operator.
Inspect and repair clutches.
9926813 R04 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.