Transmission Service; Transmission Removal - Polaris RZR 570 2013 Service Manual

TRANSMISSION

TRANSMISSION SERVICE

TRANSMISSION REMOVAL

CAUTION
Correct Drive Clutch Puller P/N PA-48595
1. If internal transmission repair is required, drain the
transmission lubricant
Transmission Lubrication, page 2.25).
2. Remove the seats and engine service panel (see
Chapter 10 – BODY COMPONENT REMOVAL,
page ).
3. Disconnect the (-) negative battery cable from the
battery.
4. Raise and support the vehicle.
CAUTION
Serious injury may result if machine tips or falls. Be
sure machine is secure before beginning this
procedure. Always wear eye protection.
5. Remove rear wheels from the vehicle.
6.6
(see Chapter 2 –
6. From the right-hand front wheel well, locate the
propshaft roll pin. Use the Roll Pin Removal Tool to
remove the roll pin from the front gearcase.
Roll Pin Removal Tool:
2872608
7. Remove the gear selector cap and remove the
retaining screw and handle.
8. Remove the Torx screws retaining the center console
to access the propshaft.
9. Slide prop shaft back far enough to remove it from
the front gearcase input shaft splines.
10. Pull sharply forward to remove the propshaft from
transmission shaft.
11. Remove the rear bumper and cargo box as an
assembly (see Chapter 10 – BODY COMPONENT
REMOVAL, page ).
9926813 R04 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.