Polaris RZR 570 2013 Service Manual page 321

8. Remove the Torx screws retaining the center console
to access the propshaft.
9. Remove the T-27 Torx screws and the push pins
securing the driver's side floor, left-hand rocker panel
and the rear left-hand panel divider as outlined in
Chapter 5.
10. Gently lift and support floor and panel divider upward
in order to allow the prop shaft to pass beneath
them.
11. Slide prop shaft back far enough to remove it from
the front gearcase input shaft splines.
12. Pull sharply forward to remove the propshaft from
transmission shaft.
9926813 R04 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.
13. Position prop shaft to the right-hand side of the front
gearcase as shown.
14. Maneuver the rear of the propshaft towards the left-
hand side of the vehicle under the drivers side floor
and rear left-hand panel divider in the battery area.
Note angle of propshaft below.
15. Remove the propshaft from the left-hand rear wheel
well area.
FINAL DRIVE
7
7.23