Battery Activation; Battery Removal / Installation - Polaris RZR 570 2013 Service Manual

ELECTRICAL

BATTERY ACTIVATION

WARNING
Battery electrolyte is poisonous. It contains sulfuric
acid. Serious burns can result from contact with skin,
eyes or clothing. Antidote:External: Flush with water.
Internal: Drink large quantities of water or milk. Follow
with milk of magnesia, beaten egg, or vegetable oil. Call
physician immediately.Eyes: Flush with water for 15
minutes and get prompt medical attention.Batteries
produce explosive gases. Keep sparks, flame,
cigarettes etc. away. Ventilate when charging or using
in an enclosed space. Always shield eyes when
working near batteries. KEEP OUT OF REACH OF
CHILDREN.
WARNING
The gases given off by a battery are explosive. Any
spark or open flame near a battery can cause an
explosion which will spray battery acid on anyone close
to it. Should there be contact with battery acid, wash the
affected area with large quantities of cool water and
seek immediate medical attention.
To ensure maximum service life and performance from a
new battery, perform the following steps. NOTE: Do not
service the battery unless it will be put into regular
service within 30 days. After initial service, add only
distilled water to the battery. Never add electrolyte after a
battery has been in service.
New Battery: Battery must be fully charged before use
or battery life will be significantly reduced 10-30% of the
battery's full potential.
To activate a new battery:
1. Remove all the filling plugs.
2. Remove the sealing tube (red cap) from vent fitting.
3. Place battery on a level surface. Fill battery with
electrolyte to upper level marks on the battery case.
Never activate a battery on the vehicle. Electrolyte spills
can cause damage.
4. Set battery aside to allow for acid absorption and
stabilization for 30 minutes.
5. Add electrolyte to bring the level back to the upper
level mark on the battery case.
6. Charge battery for 10 - 17 hours at 1 to 1.5 AMPS.
11.26
NOTE
NOTE
7. Check during initial charging to see if electrolyte level
has fallen, and if so, fill with acid to the upper level.
After adding, charge for another hour at the same
rate.
This is the last time that electrolyte should be added. If
the level becomes low after this point, add only distilled
8. When charging is complete, install the filling plugs
firmly.
Do not apply excessive pressure. Finger tighten only.
Do not over-tighten.
9. Wash off spilled acid with water and baking soda
solution, paying particular attention that any acid is
washed off the terminals. Dry the battery case.

BATTERY REMOVAL / INSTALLATION

See Chapter 2 "Maintenance" for battery removal and
installation procedures.
9926813 R04 - 2013-2016 RZR 570 Service Manual
NOTE
water.
NOTE
© Copyright Polaris Industries Inc.