Zeiss S88 Instructions For Use Manual page 58

58
G-30-1426-en
Description
Components
The principal component of the TFT monitor is the 15" screen which de-
livers flawless, sharp images even at low frame rates of 50 Hz.
The connectors and controls are located under cable cover (2) on the
back of the TFT monitor. To access the connectors and controls, proceed
as follows:
• Remove two screws (3) from cable cover (2) by turning them counter-
clockwise.
• Remove cable cover (2) by pushing it upward.
Controls
1 Auto Adjust button
The Auto Adjust function permits automatic image adjustment of the
TFT monitor to obtain a sharp, optimally positioned image. Perform
the automatic adjustment when initially starting up the TFT monitor or
after making any changes to the system.
Note:
– The Auto Adjust function can only be executed if a VGA signal
source is connected.
– Always use a normal camera image for automatic image adjust-
ment. Do not use the test image which is displayed directly after
power-on or when no camera head is connected.
S88 Floor Stand with Lifting Column Issue 9.0
Printed on 28. 01. 2009