Zeiss S88 Instructions For Use Manual page 117

Configuration
mode 5
SETTINGS 4
AF-CCD
SIZE
1/2"
MODE STORE MANUAL
G-30-1426-en
Operation
Roll-over procedure:
Path: To return to the basic mode, press the MODE button in the config-
uration mode, or do not press any button for 20 seconds.
To change to configuration mode 5 (SETTINGS 5), simultaneously
press the MODE and STORE buttons in configuration mode 4.
Configuration mode 5 for OPMI Vario (SETTINGS 5)
Menu item "AF-CCD SIZE" in configuration mode 5 for the OPMI Vario
permits you to enter the size of the CCD array.
Path: Every time you switch on the system, the basic mode is automati-
cally displayed.
To access configuration mode 5 from the basic mode, go via con-
figuration modes 1, 2, 3 and 4 by simultaneously pressing the
"MODE" and "STORE" buttons five times successively.
Entering the size of the CCD array, menu item "AF-CCD SIZE"
Note:
This setting is performed during the installation of the SpeedFokus (auto-
focus) option. It is a camera-specific setting which only needs to be
changed when a different video camera is installed.
The size of the CCD array (chip size) of the video camera currently used
must be known to the SpeedFokus (autofocus) option. This menu item is
used to specify this camera-specific value to the SpeedFokus (autofocus)
option.
This setting must always conform to the technical specifications of the
video camera used. The SpeedFokus (autofocus) option does not func-
tion properly if parameters have not been correctly set.
You can select the relevant size of the CCD array from the values offered.
Roll-over procedure:
Path: To return to the basic mode, press the MODE button in the config-
uration mode, or do not press any button for 20 seconds.
S88 Floor Stand with Lifting Column
→ 50 → 60 →
↑
← 105 ← 85 ←
1 1
→ " → " →
-- - -- -
4 3
↑
← 1 ←
"
-- -
2
117
↓
↓
Issue 9.0
Printed on 28. 01. 2009