Relocating The Unit - Zeiss S88 Instructions For Use Manual

82

Relocating the unit

G-30-1426-en
Preparations for use
Note:
As the stand is very easy to maneuver, there is a tendency to underesti-
mate its considerable weight. Therefore, move the stand slowly and care-
fully!
Please observe the following points when relocating the stand:
• Move the lifting column downwards until stop.
• Fold the suspension arm to its moving position (see illustration on the
opposite page).
• Switch off the illumination system via the knobs and the unit at its pow-
er switch.
• Unplug the power cord from the wall outlet.
• Wind up the cable of the foot control panel on a cable support and
hang the foot control panel on the handle.
• Wind up the power cord on the other cable support.
• Use the maneuvering handle for moving the stand.
• Be careful of heights when passing through doorways.
• Avoid collisions of any kind.
• Do not go over steps and edges: The stand might topple!
• Be extremely careful when moving over slopes.
• Do not park the stand on slopes.
• Press the locking pedals to lock the stand in position. Make sure that
the stand is no longer able to roll away by itself.
Caution:
Over longer distances (e.g. removal, return for repair, etc), the instrument
must always be transported in the original packaging or in special return
packaging. For details, please contact your dealer or the Carl Zeiss
service team.
S88 Floor Stand with Lifting Column Issue 9.0
Printed on 28. 01. 2009