Zeiss S88 Instructions For Use Manual page 108

108
2
1
3
Configuration
mode 1
SETTINGS 1
FOOT
LEFT C:
PHOTO
FOOT
RIGHT D:
PHOTO
HAND
GRIP:
LIGHT
STORE MANUAL
MODE
G-30-1426-en
Operation
Roll-over procedure:
→ AF
↑
← AUX ← PHOTO ← ZOOM-MEM ←
If you have assigned FOC-MEM to key C or D of the foot control panel,
you can determine by the length of time for which you press the relevant
key of the foot control panel during operation whether a positioning run is
to be triggered (press the key for less than 2 seconds) or whether the cur-
rent position is to be saved (press the key for more than 2 seconds).
Assigning a function to the freely configurable handgrip buttons
The two upper buttons (1 and 2) on the left and right handgrips of the
OPMI Vario surgical microscope are freely configurable.
Use the menu item "HANDGRIP:" to assign one of the following functions
to the handgrip buttons:
Display Function of the left button (1) Function of the right button (2)
LIGHT Reducing brightness
MEM Focus memory
pressed for < 2 sec:
triggers positioning
Pressed for > 2 sec:
saves position
PH/AUX Camera release at the camera
interface
XY-RES XY recentering ("Reset")
AF Triggering the autofocus option
Roll-over procedure:
→
XY-RES
↑
← PH / AUX ← MEM
If the memory function (MEM) has been set for buttons (1) and (2) of the
handgrips, you can determine whether a positioning run is triggered or
whether the position is saved - simply by pressing the buttons for a longer
or shorter time.
If you press button (1) for less than 2 seconds, focus positioning is trig-
gered; if you press the button for more than 2 seconds, the current focus
S88 Floor Stand with Lifting Column
→ XY-RES → FOC-MEM
Increasing brightness
Zoom memory
pressed for < 2 sec:
triggers positioning
Pressed for > 2 sec:
saves position
Triggering an AUX signal at
the AUX interface
XY recentering ("Reset")
→
AF
← LIGHT ←
→
↓
→
↓
Issue 9.0
Printed on 28. 01. 2009