Zeiss S88 Instructions For Use Manual page 119

G-30-1426-en
Operation
Control functions for the OPMI
The control functions for the OPMI
have been combined in 4 modes:
Basic mode
– Set the lamp brightness
– Set user ID
Configuration mode 1
– allocate a function to key C of
the foot control panel
– allocate a function to key D of
the foot control panel
– Set the focus speed depending
on the zoom setting
The various control functions are explained below.
"STORE" key
In the basic mode and speed mode, the current zoom setting of the sur-
gical microscope can be stored for the user currently selected.
The "STORE" key has no function in the configuration modes.
The current zoom value is saved as zoom memory (ZOOM-MEM).
You can set the instrument to this stored zoom value by pressing key C
or D on the foot control panel if the XYZ-RES function has been assigned
to one of these keys in configuration mode 1. You can also set the stored
zoom value using the RESET key on the X-Y coupling.
Caution:
Be extremely careful when changing these settings. You should change
settings only under your own user ID. Notify all users of any changes, or
make sure that each user only works under his own user ID.
S88 Floor Stand with Lifting Column
®
VISU 150 and VISU 200
®
VISU 150 and the OPMI
Speed mode
– Default speed for focusing
– Default speed for the zoom
function
– Default speed for the X-Y cou-
pling
Configuration mode 2
– Set the magnetic brakes to be
released by activating the re-
lease key in the guiding knob.
Printed on 28. 01. 2009
119
®
VISU 200
Issue 9.0