Table of Contents
Advertisement
Section 2
Operation
Software Version
Software Version is for factory use only and will be important if
troubleshooting the microprocessor programming is ever necessary.
To view this information,
open the Configuration
menu by pressing the
down arrow, up arrow and
Silence button, then the
down arrow four times, in
the sequence shown at right. The screen below will appear on the display:
Actual
Return
Setpoints
SwVers O-Temp
Press the Time button beneath SwVers and the screen at above right will
appear, showing the Model SHKE435HP/SHKE436HP software version
in the control system memory.
To return to the previous screen, press the Time button. To return to the
Operating Screen, wait about 15 seconds.
Overtemp Sensor
Readings
Overtemp Sensor Readings is for factory use only and will be important if
troubleshooting the microprocessor programming is ever necessary.
To access this screen, press
the down arrow, up arrow,
Silence button, then the
down arrow button four
more times.
Actual
Return
The screen shown at the right will
Setpoints
SwVers O-Temp
appear on the display.
Press the Speed button beneath O-
Actual
Over Temp.
37.2
Temp and the screen at the right will
Setpoints
appear, showing the temperatures being
read by the Overtemperature sensor.
When finished, press any of the three buttons (Time, Speed, or Temp) to
save the new setpoint value and return to the previous screen, or press
nothing for about 15 seconds to save the new setpoint value and return to
the Operating Screen.
Thermo Scientific
Orbital Shaker
2-17
Advertisement
Table of Contents
