Operation; Pushbuttons - Smartgen HGM7110DC User Manual

4 OPERATION

4.1. PUSHBUTTONS

Stop
Start
Manual Mode
Auto Mode
Close/Open
Mute/Reset
Alarm
Raise Speed
Drop Speed
Menu/Confirm
Up/Increase
Down/Decrea
se
NOTE: Pressing
passwords allows the users to set parameters.
NOTE: Pressing
and simultaneously will decrease LCD contrast; When controller is powered on after
outage, LCD contrast will return factory default.
WARNING: Default password is 00318, user can change it in case of others change the
advanced parameters setting. Please clearly remember the password after changing. If you
forget it, please contact Smartgen services and send all information in the controller page of
"ABOUT" to us.
HGM7110DC Genset Controller
Stop running generator in Auto/Manual mode; Lamp test (press at
least 3 seconds); Reset alarm in stop mode; During stopping
process, press this button again to stop generator immediately.
Start genset in Manual mode.
Press this key and controller enters in Manual mode.
Press this key and controller enters in Auto mode.
Can control generator to switch on or off in Manual mode.
Alarming sound off; If there is trip alarm, pressing the button at
least 3 seconds can reset this alarm.
Control the genset accelerate in Manual mode.
Control the genset decelerate in Manual mode.
1) Enter into Menu interface;
2) Shift cursor and confirm the set information.
1) Screen scroll;
2) Up cursor and increase value in setting menu.
1) Screen scroll;
2) Down cursor and decrease value in setting menu.
to enter into Menu interface; select "Parameters" and input correct
and simultaneously will increase LCD contrast; Pressing
Version: 1.0
HGM7110DC Genset Controller
2014-09-27 Page 11 of 68