Smartgen HGM7110DC User Manual page 43

30 Open Gen Output
1#Acc Load Close
31
32 1#Acc Load Open
33 Start Relay
34 Fuel Relay
35
36
37 Reserved
38
39
40 ECU Stop
41 ECU Power
42 Reserved
43 Crank Success
44 Reserved
45
46
Reserved
47
48 Common Alarm
49 Common Trip and Stop
50 Common Shutdown
51 Common Trip Alarm
52 Common Warn Alarm
53 Reserved
54 Battery High Volts
55 Battery Low Volts
56 Charge Alt Fail
57 1#Acc Charge Close
58 1#Acc Charge Open
59 Measuring Gen Volts
60 ECU Warn
61 ECU Shutdown
62 ECU Com Fail
63 2#Acc Charge Close
64 2#Acc Charge Open
1# Acc. Over Voltage
65
Warn
66 1# Acc. Under Voltage
HGM7110DC Genset Controller
Control generator to off load.
Two Accs：Control 1# accumulator to take load.
Two Accs：Control 1# accumulator to off load.
Action when genset start and disconnect when
genset stop completely.
Used for ECU engine and control its stop.
Used for ECU engine and control its power.
Close when detects a successful start signal.
Action when genset common warning, common
shutdown, common trips alarm.
Action when common trip and stop alarm.
Action when common shutdown alarm.
Action when common trips alarm.
Action in common warning alarm.
Action when battery's over voltage warning alarm.
Action when battery's low voltage warning alarm.
Action when charge failure warning alarms.
Control 1# accumulator charge switch to close.
Control 1# accumulator charge switch to open.
Two accumulator system detect the Gen voltage or
2# Accumulator Voltage effectively.
Indicate ECU sends a warning signal.
Indicate ECU sends a shutdown signal.
Indicate controller not communicates with ECU.
Control 2# accumulator charge switch to close.
Control 2# accumulator charge switch to open.
Version: 1.0
HGM7110DC Genset Controller
2014-09-27 Page 43 of 68