Smartgen HGM7110DC User Manual page 30

NO. Functions
39 Aux. Input COM
40 CANBUS SCR
41 CAN-
42 CAN+
43 RS485 SCR
44 RS485+
45 RS485-
46 GND
47 Engine Temp.
48 Oil Pressure
49 Fuel Level
50 Config. Sensor 1
51 Config. Sensor 2
52 Sensor COM
53 RS232(GND)
54 RS232 TX
55 RS232 RX
NOTE: USB ports in controller rear panel are configurable parameter ports, user can
directly program controller via PC.
NOTE: If 1# accumulator/2# accumulator temperatures need to be detected, Configured
sensor 1/ sensor 2 should be set as "Temperature Sensor".
HGM7110DC Genset Controller
Cable
Remark
Size
A common terminal of input port, (-Ve) has
2
1.0mm
already connected internal.
2
0.5mm
Impedance-120Ω
2
0.5mm recommended,
2
CANBUS, no these terminals)
0.5mm
2
0.5mm
Impedance-120Ω
2
0.5mm recommended,
2
RS485, no these terminals)
0.5mm
Connect to temperature Sensor.
Connect to oil pressure sensor.
Connect to fuel level sensor.
Connect to temperature sensor,
oil pressure sensor or fuel level
sensor.
A common terminal of sensor, (-Ve) has NOT connected
internal.
2
0.5mm
2
0.5mm Connected to GSM module.
2
0.5mm
Version: 1.0
HGM7110DC Genset Controller
shielding
its single-end earthed.
shielding
its single-end earthed.
Details see form 4
2014-09-27 Page 30 of 68
wire is
(No
wire is
(No