Table of Contents
Advertisement
STEP 12. PROGRAM CDM
The monitoring system requires programming
for each header and the header must be
attached to the windrower. Programming the
system may be accomplished with or without the
engine running.
If the engine is running, the
transmission must be in neutral. If the engine is
not running, the ignition must be on.
programming mode at any time by pressing the
PROGRAM switch or by turning off the ignition.
The system only needs to be programmed once
for each header.
changes later on to a particular setting to suit
windrowing conditions or modifications to the
machine.
Most functions have been pre-
programmed at the factory but can be changed
by the operator if required.
Proceed as follows to program the CDM:
a. Turn ignition key to RUN, or start the engine.
See II. START ENGINE on page 41.
b. Press PROGRAM and SELECT on CDM to
enter programming mode.
SIDE DISPLAY
Displays Software Revision Status
Upper Line – C### (CDM)
Lower Line – M### or T### (WCM)
PROGRAM SWITCH
Places Monitor Into Program Mode
Press While Depressing SELECT Switch.
Press To Exit Program Mode.
Form # 169390
UNLOADING AND ASSEMBLY
Exit
The operator may make
MENU ITEM SCROLL BACKWARD
Displays Value Under Menu Item
Push To Scroll Backward.
Keep Depressed For Fast Scroll. *
c. Press
SELECT.
displayed on upper line.
d. Press
and then SELECT.
e. HEADER TYPE? is displayed.
flashing on lower line.
f.
Press
or
line.
g. Press SELECT.
h. TILT CYL INSTALLED? is displayed.
i.
Press
or
line.
j.
Press SELECT to advance to the next L1 item
and press arrow keys to change values.
k. Press PROGRAM to exit programming mode
when finished entering desired values.
Refer to Detailed Programming Instructions on
following pages.
Contact
information
updates to the electronic modules.
MENU ITEM SCROLL FORWARD
Push To Scroll Forward.
Keep Depressed For Fast Scroll. *
* Fast scroll applies only when changing
OVERLOAD SPEED (with expansion module),
and TIRE SIZE.
29
TRACTOR
SETUP?
DRAPER is
to change value on lower
to change value on lower
NOTE
the
manufacturer
regarding
software
MAIN DISPLAY
Displays Menu Item and Selection
Upper Line – Menu Item
Lower Line - Selection
SELECT SWITCH
Places Monitor Into Program
Mode With PROGRAM SWITCH
Press to Accept Menu Item and
Advance to Next Item.
Displays Value Under Menu Item
Model Year - 2010
is
for
Advertisement
Table of Contents
