Table of Contents
Advertisement
h. Install pin (A) through each boot and foot and
secure with hairpin..
IMPORTANT
Ensure pin (A) is fully inserted and
hairpin is installed behind bracket.
i.
Remove lynch pin from pin (J) in stand (K).
j.
Hold stand and remove pin (J).
k. Reposition stand to storage position by inverting
stand and re-locating on bracket as shown.
Reinsert pin (J) and secure with lynch pin.
l.
Remove pin (L) from storage position in linkage
and insert in hole (M) to engage float springs.
Secure with lynch pin.
Form # 169390
UNLOADING AND ASSEMBLY
A
K
J
L
M
m. Disengage lift cylinder stops.
n. Start engine, and activate header lift cylinder
switch on GSL to lower header fully.
engine and remove key.
o. Connect header drive hydraulics (N) and
electrical harness (O) to header. Refer to Auger
Header Operator's Manual.
26
O
N
Model Year - 2010
Stop
Advertisement
Table of Contents
