Step 11. Program Cdm - MacDon M150 Assembly Instructions Manual

STEP 11. PROGRAM CDM

The monitoring system requires programming
for each header and the header must be
attached to the tractor.
system may be accomplished with or without the
engine running. If the engine is running, the
transmission must be in neutral. If the engine is
not running, the ignition must be on.
programming mode at any time by pressing the
PROGRAM switch or by turning off the ignition.
The system only needs to be programmed once
for each header.
changes later on to a particular setting to suit
windrowing conditions or modifications to the
machine. Most functions have been pre-
programmed at the factory but can be changed
by the operator if required.
The following functions can be programmed by
the dealer provided he has the applicable
information from the operator and the header is
installed:
•
DWA INSTALLED
•
HDR CUT WIDTH
•
HAY CONDITIONER INSTALLED
•
CALIBRATE SENSORS
SIDE DISPLAY
Displays Software Revision Status
Upper Line – D### (CDM)
Lower Line – C### (WCM)
PROGRAM SWITCH
Places Monitor Into Program Mode
Press While Depressing SELECT Switch
Press To Exit Program Mode.
Form # 169018
UNLOADING AND ASSEMBLY
Programming the
The operator may make
MENU ITEM SCROLL BACKWARD
Displays Value Under Menu Item
Push To Scroll Backward.
Keep Depressed For Fast Scroll. *
Proceed as follows to program the CDM:
Header must be attached to the
tractor. See STEP 9.
a. Turn ignition key to RUN, or start the engine.
Refer to STEP 12.J. II START ENGINE.
b. Press PROGRAM and SELECT on CDM to
enter programming mode. Header ID code is
Exit
displayed.
c. Press
displayed.
d. Press
e. Press SELECT until DWA INSTALLED? is
displayed.
f. Press
g. Press SELECT to advance to the next L1 item.
h. Press PROGRAM to exit programming mode.
i. Refer to Detailed Programming Instructions on
following pages.
The functions requiring programming
are hi-lited.
If necessary, refer to the M150, M200
Windrower
programming CDM to specific crop
types and conditions.
29
IMPORTANT
SELECT. TRACTOR
. SET KNIFE SPEED? is displayed
or .
NOTE
NOTE
Operator's
MAIN DISPLAY
Displays Menu Item and Selection
Upper Line – Menu Item
Lower Line - Selection
SELECT SWITCH
Places Monitor Into Program
Mode With PROGRAM SWITCH
Press to Accept Menu Item and
Advance to Next Item.
MENU ITEM SCROLL FORWARD
Displays Value Under Menu Item
Push To Scroll Forward.
Keep Depressed For Fast Scroll. *
SETUP? is
Manual for
Model Year - 2009