Table of Contents
Advertisement
If you want to set your own length for the duration of the delay after
activa-tion, scan the After Activation bar code below, then set the time-
out by scanning digits (0-65535 seconds) from the
then scanning Save. Default = 0 seconds.
Output Sequence Overview
Require Output Sequence
When turned off, the bar code data will be output to the host as the engine
decodes it. When turned on, all output data must conform to an edited
sequence or the engine will not transmit the output data to the host device.
See
Require Output Sequence
Output Sequence Editor
This programming selection allows you to program the engine to output
data (when scanning more than one symbol) in whatever order your
appli-cation requires, regardless of the order in which the bar codes are
scanned. Reading the Default Sequence symbol programs the engine to
the following Universal values. These are the defaults. Be certain you
want to delete or clear all formats before you read the Default Sequence
symbol.
Note: If CodeGate is enabled, you must hold the external trigger down
while reading each
Note: To make Output Sequence Editor selections, you'll need to know
the code I.D., code length, and character
application
Programming Chart
To Add an Output Sequence
1. Scan the Enter Sequence symbol (see
Output
Sequence, page 3-21).
2. Code I.D.
On the
Symbology Charts
you want to apply the output sequence format. Locate the Hex value
for that symbology and scan the 2 digit hex value from the
Programming Chart
3. Length
Specify what length (up to 9999 characters) of data output will be
acceptable for this symbology. Scan the four digit data length from the
Programming
After
Activation
on page 3-21 for further information.
bar code in a sequence.
requires. Use the Alphanumeric symbols on the
to read these options.
on page A-1, find the symbology to which
(inside back cover).
Chart. (Note: 50 characters is entered as 0050. 9999 is
Programming
match(es) your
Require
Chart,
3-17
Advertisement
Table of Contents
