Table of Contents
Advertisement
Power Save Mode Timeout
This allows you to set the length (in seconds) for power save timeout. To set
the length scan the Power Save Timeout bar code below, then set the timeout
(from 0-65535 seconds) by scanning digits from the
Programming
Chart, then
scanning Save. The scan engine goes into a power save mode (Sleep or
Hiber-nate) at timeout after a successful scan or the duration of inactivity.
Default = 600 seconds.
Power Save Timeout
* 600 Seconds
Power Save Mode
The scan engine has three Power Save Modes: Off, Sleep Mode, and Hiber-
nate. In Off mode, all components are powered on and the scan engine is in
operating mode. In Sleep Mode, the laser, motor, and micro are powered off.
In Hibernate, all components are powered off. The scan engine enters Power
Save Mode after the timeout occurs. See
Power Save Mode Timeout
on page
3-15 for further information. Default = Off.
* Off
Sleep Mode
Hibernate
Aimer Control
To control engine's aimer before and after scanning or to control the aimer
with an external aiming pin, scan one of the bar codes below. Default = Aimer
Always Off.
3-15
Advertisement
Table of Contents
