Table of Contents
Advertisement
Addenda Timeout
You can set a time during which the engine looks for an addenda. If an
addenda is not found within this time period, the data can be either trans-
mitted or discarded, based on the setting you are using for
Addenda
Required. Set the length (in milliseconds) for this timeout by
scanning the bar code below, then setting the timeout (from 0-65535
milli-seconds) by scanning digits from the
scanning Save. Default = 100.
Note: The Addenda Timeout setting is applied to all addenda and coupon
code searches.
EAN/JAN-13 Addenda Separator
When this feature is On, there is a space between the data from the bar
code and the data from the addenda. When turned Off, there is no
space. Default = Off.
On
Note: If you want to enable or disable EAN13 with Extended Coupon Code,
refer to
UPC-A/EAN-13 with Extended Coupon
EAN/JAN-13 Redundancy
If you are encountering errors when reading EAN/JAN-13 bar codes, you
may want to adjust the redundancy count. Redundancy adjusts the num-
ber of times a bar code is decoded before transmission, which may
reduce the number of errors. Note that the higher the redundancy count,
the lon-ger it will take to decode the bar code. To adjust the redundancy,
scan the EAN/JAN-13 Redundancy bar code below, then scan a
redundancy count between 0 and 10 on the
the back cover of this manual. Then scan the
Addenda Timeout
EAN/JAN-13 Redundancy
Programming
Chart, then
* Off
Code (page
Programming Chart
Save
bar code. Default = 0.
EAN/JAN-13
6-37).
inside
6-51
Advertisement
Table of Contents
