Chapter 1 - Getting Started; Introduction; About This Manual; Unpacking Your Device - Honeywell N431X User Manual

Decoded laser scan engine
Table of Contents

Advertisement

1
Getting Started

Introduction

The N431X engine is designed for integration into a wide range of OEM
devices. The engine's compact mechanical design can drop into many existing
applications, allowing OEMs and third-party manufacturers to integrate the
ben-efits of laser-based scanning into a variety of devices, including hand held
com-puters (PDTs, medical instrumentation, kiosks, diagnostic equipment, and
robotics).

About This Manual

This User's Guide provides demonstration, installation, and programming
instructions for the N431X engine. Product specifications, dimensions, war-
ranty, and customer support information are also included.
Honeywell's bar code engines are factory programmed for the most common
terminal and communications settings. If you need to change these settings,
programming is accomplished by scanning the bar codes in this guide.
An asterisk (*) next to an option indicates the default setting.

Unpacking Your Device

After you open the shipping carton containing the OEM engine(s), take the
fol-lowing steps:
• Check for damage during shipment. Report damage immediately to the
carrier who delivered the carton.
• Make sure the items in the carton match your order.
• Save the shipping container for later storage or shipping.

Connecting the Development Engine to the PC

The development OEM engine can connect to a PC for evaluation.
Note: The development board and the kit components are not intended for
integration and should ONLY be used for evaluation of the engine.
1.
Turn off power to the terminal/computer.
2.
If using a USB connection, connect the included interface cable to
the engine and to the matching USB port on the back of the
computer. Skip to step 5.
Note: For additional USB programming and technical information, refer
to Honeywell's "USB Application Note," available at
www.honeywellaidc.com.
Note: For USB connection only: Connecting power to both the micro-B
connector and the 10 pin RJ45 connector simultaneously could
damage the PC and/or the engine.
1 - 1

Advertisement

Table of Contents
loading

Table of Contents