Character Activation Mode; Activation Character; End Character Activation After Good Read - Honeywell N431X User Manual

Character Activation Mode

You may use a character sent from the host to trigger the engine to begin
scan-ning. When the activation character is received, the engine continues
scanning until either the
deactiva-tion character is received (see
or a bar code is transmitted. Scan the following On bar code to use character
activation, then use Activation Character (following) to select the character you
will send from the host to start scanning. Default = Off.
* Off

Activation Character

This sets the character used to trigger scanning when using Character
Activation Mode. On the
value that represents the character you want to use to trigger scanning.
Scan the following bar code, then use the
alphanumeric combination that represents that ASCII character. Scan
Save to finish.

End Character Activation After Good Read

After a bar code is successfully detected and read from the engine, the laser
can be programmed either to remain on and scanning, or to turn off. When
End Character Activation After Good Read is enabled, the laser
3-10
Character Activation Laser Timeout
Deactivation Character
ASCII Conversion
Activation Character
(page 3-11), the
On
Chart, page A-3, find the hex
Programming Chart
on page 3-11),
to read the