Table of Contents
Advertisement
If this bar code is read:
AB1234
<CR>
Insert a delay
EF Inserts a delay of up to 49,995 milliseconds (in multiples of 5),
starting from the current cursor position. Syntax = EFnnnn where
nnnn stands for the delay in 5ms increments, up to 9999. This
command can only be used with keyboard emulation.
Discard Data
B8 Discards types of data. For example, you may want to discard Code
128 bar codes that begin with the letter A. In step 4
6A (for Code 128), and in step 5, select 9999 (for all lengths). Enter
FE41B8 to compare and discard Code 128 bar codes that begin with
the letter A. Syntax = B8.
Note: The B8 command must be entered after all other commands.
The Data Format must be Required (see page 5-16) in order for
the B8 command to work. If Data Format is On, but Not Required
(page
and output as usual.
Other data format settings impact the B8 command. If Data Format
Non-Match Error Tone is On
error tone. If Data format Non-Match Error Tone is Off, the code is
disabled for reading and no tone is sounded.
Data Formatter
When Data Formatter is turned Off, the bar code data is output to the host
as read, including prefixes and suffixes.
You may wish to require the data to conform to a data format you have
created and saved. The following settings can be applied to your data format:
Data Formatter On, Not Required, Keep Prefix/Suffix
Scanned data is modified according to your data format, and prefixes
and suffixes are transmitted.
Data Formatter On, Not Required, Drop Prefix/Suffix
Scanned data is modified according to your data format. If a data format
is found for a particular symbol, those prefixes and suffixes are not
transmitted. If a data format is not found for that symbol, the prefixes and
suffixes are transmitted.
5-16), bar code data that meets the B8 format is scanned
Data Formatter Off
the data is output as:
(page
5-17), the engine emits an
(page
5-2), select
5-15
Advertisement
Table of Contents
